|
HyperTerminal
Tutorial
How to use the HyperTerminal program for testing device
communications
Remote
Access
Some possibilities for monitoring and controlling devices from a
distance.
A
case for the K145
Installing the K145 board into a case.
Another
case for the K145
An alternate technique for mounting the board.
A
case for the VK011
Installing the VK011 board into a case.
Build
a K145 Temperature Controller
Adapting the K145 for 2 channels of temperature
control.
What kind of cable should I
use?
A brief discussion of cable types and requirements for cabling 1-Wire sensors.
Operating and Setup Tips
Hints on working with boards, sensors, etc.
Identifying
Resistor and Capacitor values
For kit builders.
Writing
Your Own Program
Some tips and techniques for those wanting to try their hand at writing their
own program.
Start
a program at system bootup.
Useful for automatic recovery after power failure.
Troubleshooting
Tips
Hints on sorting out kit and software problems.
Defective
1-Wire Sensors
Not all temperature sensors are created equal.
|
